RouterGeek » interface

How to Configure a Cisco Router as a Frame-Relay Switch

  0 comments

  7th Dec 11

  Mohammed Alani

When would you need this: When are setting up your own Frame-Relay network. Usually, it is used for lab setup.

Special Requirements: A Cisco router with at least two serial interfaces.

Read the rest of this entry »

  General

  cisco, configuration, dlci, frame, frame-realy, interface, router, switch
How to Configure HDLC on a Cisco Router

  0 comments

  7th Dec 11

  Mohammed Alani

When would you need this: When you connect two Cisco routers through a WAN connection, or back-to-back router setup.

Special Requirements: Both routers needs to be Cisco routers.

Read the rest of this entry »

  General

  cisco, config, configuration, hdlc, interface, router, serial
10 show Commands Everybody Needs To Know in Cisco Routers

  0 comments

  24th Apr 07

  Mohammed Alani

Some commands in the Cisco router configuration are just irreplaceable. The ‘show’ commands are the most widely used in Cisco routers. Here is a list of the 10 mostly used of these ‘show’ commands.

Read the rest of this entry »

  Hints and Tips

  address, cisco, config, configuration, flash, interface, ip, router, run, show, start