RouterGeek

The Cisco Routers How-To Reference


    • About RouterGeek
    • Contact Us
    • Terms of Use
    • Categories

      • General (27)
      • Hints and Tips (3)
      • Security (3)
      • 2500 Series (1)
      • 2600 Series (1)
    • Ads

    • Tags

      1600 2500 2600 3600 access-list address authentication backup boot cisco config configuration configure dhcp flash ftp global hyperterminal install interface internet ios ip isdn isp lost nat network ospf password pcmcia procedure protocol recover router routing run security sequence show start subnet tftp tips upgrade
    • Books from Amazon




    • How to Upgrade IOS of a Cisco Router Using HyperTerminal

        0 comments
        9th Apr 07
        Mohammed Alani

      When would you need this: When you want to upgrade the IOS file and you do not have TFTP of FTP servers around, so you turn to the good old console for the upgrade.

      Special Requirements: The router flash size should be adequate for the new IOS image, and you should have enough RAM in the router for the operation and temporary storage of the new IOS file.

      Read the rest of this entry »

        General
        boot, cisco, console, flash, ftp, hyperterminal, ios, router, tftp, upgrade, xmodem
    • How to Upgrade or Install IOS on Cisco Router using ROMmon mode

        0 comments
        4th Apr 07
        Mohammed Alani

      When would you need this: If your router flash, or IOS file are corrupted, you can use this procedure to install a new IOS file. Also, when you plan to upgrade your IOS file you can use this procedure.

      Special Requirements: The router flash size should be enough for the new IOS file.

      Read the rest of this entry »

        General
        boot, boot mode, cisco, corrupted, flash, ios, rommon, router, server, tftp, upgrade
    • How to Upgrade IOS on a Cisco Router

        2 comments
        4th Apr 07
        Mohammed Alani

      When would you need this: The upgrade is required when you plan to add more duties to the router or new hardware. The installation is required when the IOS image you have on the router is corrupted.

      Special Requirements: The router’s flash size should be enough for the new IOS image.

      Read the rest of this entry »

        General
        2600, 3600, boot, cisco, install, ios, procedure, router, upgrade
    • Search Routergeek.net

    • Follow Us


      My Great Web page
    • Our Amazon Store


      Take a look into RouterGeek Store
    Copyright © Mohammed M. Alani .All rights reserved.
    Sitemap